[LUAU] I still don't get it :(

[Myles Uyema]

> (--) Mach64: Mode "1600x1200" needs hsync freq of 105.77 kHz. Deleted.
> (--) Mach64: Mode "1280x1024" needs hsync freq of 107.16 kHz. Deleted.
> (--) Mach64: Mode "1800X1440" needs hsync freq of 96.15 kHz. Deleted.
> (--) Mach64: Mode "1800X1440" needs hsync freq of 104.52 kHz. Deleted.
> 
>  *** None of the configured devices were detected.***
> 
> 
> Fatal server error:
> no screens found
>

XF86Config file...
>
> # NOTE: THE VALUES HERE ARE EXAMPLES ONLY.  REFER TO YOUR MONITOR'S
> # USER MANUAL FOR THE CORRECT NUMBERS.
> 
>     HorizSync  30-94
> 
> # VertRefresh is in Hz unless units are specified.
> # VertRefresh may be a comma separated list of discrete values, or a
> # comma separated list of ranges of values.
> # NOTE: THE VALUES HERE ARE EXAMPLES ONLY.  REFER TO YOUR MONITOR'S
> # USER MANUAL FOR THE CORRECT NUMBERS.
> 
>     VertRefresh 48-160
> 

Direct your attention to the HorizSync line in your XF86Config file.
Also make note of the (---) messages in the Xserver error output.
Because of "HorizSync 30-94" the Xserver decided it can't use any
modelines in your configuration file.  So it quits because, quite
naturally, no "screens" can be found.  "Screens" in this case, means a
"Modeline" it can use within the scope of the XF86Config guidelines.