Linux version 2.4.18-6mdk (quintela@bi.mandrakesoft.com) (gcc version 2.96 
20000731 (Mandrake Linux 8.2 2.96-0.76mdk)) #1 Fri Mar 15 02:59:08 CET 2002
BIOS-provided physical RAM map:
BIOS-e820: 0000000000000000 - 000000000009f800 (usable)
BIOS-e820: 000000000009f800 - 00000000000a0000 (reserved)
BIOS-e820: 00000000000e6c00 - 0000000000100000 (reserved)
BIOS-e820: 0000000000100000 - 00000000040fd800 (usable)
BIOS-e820: 00000000040fd800 - 00000000040ff800 (ACPI data)
BIOS-e820: 00000000040ff800 - 00000000040ffc00 (ACPI NVS)
BIOS-e820: 00000000040ffc00 - 0000000008000000 (usable)
BIOS-e820: 00000000fff80000 - 0000000100000000 (reserved)
hm, page 040fd000 reserved twice.
On node 0 totalpages: 32768
zone(0): 4096 pages.
zone(1): 28672 pages.
zone(2): 0 pages.
Kernel command line: auto BOOT_IMAGE=linux ro root=305 devfs=mount 
hdd=ide-scsi quiet
ide_setup: hdd=ide-scsi
Local APIC disabled by BIOS -- reenabling.
Found and enabled local APIC!
Initializing CPU#0
Detected 598.625 MHz processor.
Console: colour dummy device 80x25
Calibrating delay loop... 1192.75 BogoMIPS
Memory: 126472k/131072k available (1170k kernel code, 4200k reserved, 332k 
data, 260k init, 0k highmem)
Dentry-cache hash table entries: 16384 (order: 5, 131072 bytes)
Inode-cache hash table entries: 8192 (order: 4, 65536 bytes)
Mount-cache hash table entries: 2048 (order: 2, 16384 bytes)
Buffer-cache hash table entries: 8192 (order: 3, 32768 bytes)
Page-cache hash table entries: 32768 (order: 5, 131072 bytes)
CPU: Before vendor init, caps: 0383fbff 00000000 00000000, vendor = 0
CPU: L1 I cache: 16K, L1 D cache: 16K
CPU: L2 cache: 512K
CPU: After vendor init, caps: 0383fbff 00000000 00000000 00000000
Intel machine check architecture supported.
Intel machine check reporting enabled on CPU#0.
CPU:     After generic, caps: 0383fbff 00000000 00000000 00000000
CPU:             Common caps: 0383fbff 00000000 00000000 00000000
CPU: Intel Pentium III (Katmai) stepping 03
Enabling fast FPU save and restore... done.
Enabling unmasked SIMD FPU exception support... done.
Checking 'hlt' instruction... OK.
POSIX conformance testing by UNIFIX
mtrr: v1.40 (20010327) Richard Gooch (rgooch@atnf.csiro.au)
mtrr: detected mtrr type: Intel
PCI: PCI BIOS revision 2.10 entry at 0xfd993, last bus=1
PCI: Using configuration type 1
PCI: Probing PCI hardware
Unknown bridge resource 0: assuming transparent
PCI: Using IRQ router PIIX [8086/7110] at 00:07.0
Limiting direct PCI/PCI transfers.
isapnp: Scanning for PnP cards...
isapnp: Card 'SCM SwapBox Plug and Play'
isapnp: 1 Plug & Play card detected total
Linux NET4.0 for Linux 2.4
Based upon Swansea University Computer Society NET3.039
Initializing RT netlink socket
apm: BIOS version 1.2 Flags 0x03 (Driver version 1.16)
Starting kswapd
VFS: Diskquotas version dquot_6.5.0 initialized
devfs: v1.10 (20020120) Richard Gooch (rgooch@atnf.csiro.au)
devfs: boot_options: 0x1
vesafb: framebuffer at 0xfc000000, mapped to 0xc8800000, size 16320k
vesafb: mode is 800x600x16, linelength=1600, pages=16
vesafb: protected mode interface info at c000:03b8
vesafb: scrolling: redraw
vesafb: directcolor: size=0:5:6:5, shift=0:11:5:0
Looking for splash picture.... found (800x600, 53754 bytes).
Console: switching to colour frame buffer device 80x16
fb0: VESA VGA frame buffer device
pty: 256 Unix98 ptys configured
Serial driver version 5.05c (2001-07-08) with HUB-6 MANY_PORTS MULTIPORT 
SHARE_IRQ SERIAL_PCI ISAPNP enabled
ttyS00 at 0x03f8 (irq = 4) is a 16550A
block: 128 slots per queue, batch=32
RAMDISK driver initialized: 16 RAM disks of 32000K size 1024 blocksize
Uniform Multi-Platform E-IDE driver Revision: 6.31
ide: Assuming 33MHz system bus speed for PIO modes; override with idebus=xx
PIIX4: IDE controller on PCI bus 00 dev 39
PIIX4: chipset revision 1
PIIX4: not 100% native mode: will probe irqs later
    ide0: BM-DMA at 0x10a0-0x10a7, BIOS settings: hda:DMA, hdb:pio
    ide1: BM-DMA at 0x10a8-0x10af, BIOS settings: hdc:DMA, hdd:pio
hda: IBM-DPTA-371360, ATA DISK drive
hdc: CRD-8400B, ATAPI CD/DVD-ROM drive
hdd: IOMEGA ZIP 250 ATAPI, ATAPI FLOPPY drive
ide0 at 0x1f0-0x1f7,0x3f6 on irq 14
ide1 at 0x170-0x177,0x376 on irq 15
hda: 26712000 sectors (13677 MB) w/1961KiB Cache, CHS=1662/255/63, UDMA(33)
hdc: Disabling (U)DMA for CRD-8400B
hdc: ATAPI 40X CD-ROM drive, 128kB Cache
Uniform CD-ROM driver Revision: 3.12
Partition check:
/dev/ide/host0/bus0/target0/lun0: p1 p2 p3 < p5 p6 p7 >
Floppy drive(s): fd0 is 1.44M
FDC 0 is a post-1991 82077
md: md driver 0.90.0 MAX_MD_DEVS=256, MD_SB_DISKS=27
md: Autodetecting RAID arrays.
md: autorun ...
md: ... autorun DONE.
NET4: Linux TCP/IP 1.0 for NET4.0
IP Protocols: ICMP, UDP, TCP, IGMP
IP: routing cache hash table of 1024 buckets, 8Kbytes
TCP: Hash tables configured (established 8192 bind 8192)
Linux IP multicast router 0.06 plus PIM-SM
NET4: Unix domain sockets 1.0/SMP for Linux NET4.0.
RAMDISK: Compressed image found at block 0
Uncompressing....done.
Freeing initrd memory: 73k freed
VFS: Mounted root (ext2 filesystem).
Mounted devfs on /dev
Freeing unused kernel memory: 260k freed
Real Time Clock Driver v1.10e
EXT2-fs warning: mounting unchecked fs, running e2fsck is recommended
Adding Swap: 248968k swap-space (priority -1)
SCSI subsystem driver Revision: 1.00
scsi0 : SCSI host adapter emulation for IDE ATAPI devices
  Vendor: IOMEGA    Model: ZIP 250           Rev: 51.G
  Type:   Direct-Access                      ANSI SCSI revision: 00
EXT2-fs warning: mounting unchecked fs, running e2fsck is recommended
PCI: Found IRQ 11 for device 00:0d.0
PCI: Sharing IRQ 11 with 01:00.0
3c59x: Donald Becker and others. www.scyld.com/network/vortex.html
00:0d.0: 3Com PCI 3c905C Tornado at 0x1000. Vers LK1.1.16
usb.c: registered new driver usbdevfs
usb.c: registered new driver hub
usb-uhci.c: $Revision: 1.275 $ time 03:23:39 Mar 15 2002
usb-uhci.c: High bandwidth mode enabled
PCI: Found IRQ 9 for device 00:07.2
PCI: Sharing IRQ 9 with 00:0c.0
usb-uhci.c: USB UHCI at I/O 0x1080, IRQ 9
usb-uhci.c: Detected 2 ports
usb.c: new USB bus registered, assigned bus number 1
hub.c: USB hub found
hub.c: 2 ports detected
usb-uhci.c: v1.275:USB Universal Host Controller Interface driver
parport0: PC-style at 0x378 [PCSPP,TRISTATE,EPP]
Linux Kernel Card Services Kernel Version
  options:  [pci] [cardbus] [pm]
Intel PCIC probe:
  Vadem VG-469 ISA-to-PCMCIA at port 0x3e0 ofs 0x00, 2 sockets
    host opts [0]: [ext mode] [isa buf]
    host opts [1]: [ext mode] [isa buf]
    ISA irqs (scanned) = 3,4,5,7,10 polling interval = 1000 ms
cs: IO port probe 0x0c00-0x0cff: clean.
cs: IO port probe 0x0100-0x04ff: excluding 0x378-0x37f 0x4d0-0x4d7
cs: IO port probe 0x0a00-0x0aff: clean.
parport0: PC-style at 0x378 [PCSPP,TRISTATE,EPP]
lp0: using parport0 (polling).
lp0: compatibility mode
PCI: Found IRQ 9 for device 00:0c.0
PCI: Sharing IRQ 9 with 00:07.2
lp0: compatibility mode
lp0: compatibility mode
lp0: compatibility mode
Splash status on console 0 changed to off
EXT2-fs error (device ide0(3,5)): ext2_free_blocks: bit already cleared for 
block 368013
Attached scsi removable disk sda at scsi0, channel 0, id 0, lun 0
sda : READ CAPACITY failed.
sda : status = 0, message = 00, host = 0, driver = 28
Current sd00:00: sense key Not Ready
Additional sense indicates Medium not present
sda : block size assumed to be 512 bytes, disk size 1GB.
/dev/scsi/host0/bus0/target0/lun0: I/O error: dev 08:00, sector 0
I/O error: dev 08:00, sector 0
unable to read partition table
Device not ready.  Make sure there is a disc in the drive.
VFS: Disk change detected on device 08:00
sda : READ CAPACITY failed.
sda : status = 0, message = 00, host = 0, driver = 28
Current sd00:00: sense key Not Ready
Additional sense indicates Medium not present
sda : block size assumed to be 512 bytes, disk size 1GB.
/dev/scsi/host0/bus0/target0/lun0: I/O error: dev 08:00, sector 0
I/O error: dev 08:00, sector 0
Device not ready.  Make sure there is a disc in the drive.
VFS: Disk change detected on device 08:00
sda : READ CAPACITY failed.
sda : status = 0, message = 00, host = 0, driver = 28
Current sd00:00: sense key Not Ready
Additional sense indicates Medium not present
sda : block size assumed to be 512 bytes, disk size 1GB.
/dev/scsi/host0/bus0/target0/lun0: I/O error: dev 08:00, sector 0
I/O error: dev 08:00, sector 0
cdrom: This disc doesn't have any tracks I recognize!
cdrom: This disc doesn't have any tracks I recognize!
cdrom: This disc doesn't have any tracks I recognize!